Orion A10E - Configuring Basic Functions of LLDP; Enabling Global LLDP; Enabling Interface LLDP

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
311
Function
Default value
Alarm notification timer
5s
9.4.4 Enabling global LLDP
After global LLDP is disabled, you cannot re-enable it immediately. Global LLDP
cannot be enabled unless the restart timer times out.
When you obtain connection information between devices through NView NNM system for
topology discovery, the A10E/A28E needs to enable LLDP, notify their information to the
neighbours mutually, and store neighbour information to facilitate the NView NNM system
queries.
Enable global LLDP for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#lldp
enable
Enable global LLDP.
After global LLDP is enabled, use the lldp
disable command to disable this function.
9.4.5 Enabling interface LLDP
Enable interface LLDP for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#interface
port port-id
Enter physical layer interface configuration
mode.
3
Alpha-A28E(config-
port)#lldp enable
Enable LLDP on an interface.
Use the lldp disable command to disable this
function.
9.4.6 Configuring basic functions of LLDP
When configuring the delay timer and period timer, the value of the delay timer
should be smaller than or equal to a quarter of the period timer value.