Orion A10E - Checking Configurations; Configuring MAC Address Limit; Configuring the Aging Time of MAC Addresses

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
38
2.1.7 Configuring MAC address limit
Configuring interface-based MAC address limit
Configure the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#interface
interface-type interface-number
Enter physical layer interface
configuration mode.
3
Alpha-A28E(config-port)#mac-
address-table threshold
threshold-value
Configure interface-based MAC
address limit.
2.1.8 Configuring the aging time of MAC addresses
Configure the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#mac-
address-table aging-time { 0
| period }
Configure the aging time of MAC
addresses. The aging time ranges from
10s to 1000000s, and can be 0 which
indicates no aging.
2.1.9 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show mac-address-table
static [ port port-id | vlan vlan-
id ]
Show static unicast MAC addresses.
2
Alpha-A28E#show mac-address-table
multicast [ vlan vlan-id ]
[ count ]
Show all Layer 2 multicast
addresses and the current multicast
MAC address number.
3
Alpha-A28E#show mac-address-table
l2-address [ count ] [ vlan vlan-
id | port port-id ]
Show all Layer 2 unicast MAC
addresses and the current unicast
MAC address number.
4
Alpha-A28E#show mac-address-table
threshold [ port-list port-list ]
Show dynamic MAC address limit.
5
Alpha-A28E#show mac aging-time
Show the aging time of dynamic
MAC addresses.