Orion A10E - Checking Configurations; Configuring Line Detection; Introduction; Line Detection

Orion Networks
A10E/A28E/A28F Configuration Guide
6 Security
Orion Networks
202
Period of loopback-detection:3s
Restore time:infinite
Port State Status exloop-act Last Last-Occur Open-Time vlan
Loop-with (ago) (ago)
-------------------------------------------------------------------------
2 Ena no trap-only -- -- -- --
3 Ena no trap-only -- -- -- --
6.11 Line detection
6.11.1 Introduction
Line detection is a module to detect physical lines and provides you with status query function,
so it can help you analyze fault source and maintain the network.
6.11.2 Preparing for configurations
Scenario
With this function, you can query status of physical lines between devices, analyze faults, and
thus maintain the network.
Prerequisite
N/A
6.11.3 Configuring line detection
Configure the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#test cable-diagnostics
port-list { all | port-list }
Detect physical link status.
6.11.4 Checking configurations
Use the following command to check configuration result.
No.
Item
Description
1
Alpha-A28E#show cable-diagnostics
port-list { all | port-list }
Show information about line
detection.