Orion A10E - Configuring VLAN on Access Interface; Configuring VLAN on the Trunk Interface

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
44
Step
Configuration
Description
2
Alpha-A28E(config)#interface
port port-id
Enter physical layer interface
configuration mode.
3
Alpha-A28E(config-
port)#switchport mode { access |
trunk }
Set the interface to Access or Trunk
mode.
2.2.6 Configuring VLAN on Access interface
Configure VLAN on the Access interface for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#interface port
port-id
Enter physical layer interface
configuration mode.
3
Alpha-A28E(config-
port)#switchport mode access
Alpha-A28E(config-
port)#switchport access vlan
vlan-id
Configure interface in Access mode
and add Access interface into
VLAN.
4
Alpha-A28E(config-
port)#switchport access egress-
allowed vlan { { all | vlan-
list } [ confirm ] | { add |
remove } vlan-list }
(Optional) configure Access
interface permitted VLAN.

The interface allows Access VLAN packets to pass regardless of configuration for
VLAN permitted by Access interface. The forwarded packets do not carry VLAN
TAG.

When setting Access VLAN, the system creates and activates VLAN automatically
if you have not created and activated VLAN in advance.

If you delete or suspend Access VLAN manually, system will set the interface
Access VLAN as default VLAN by automation.

If the configured Access VLAN is not default VLAN and there is no default VLAN
in allowed VLAN list of Access interface, the interface does not permit default
VLAN packets to pass.

Allowed VLAN list of Access interface is only effective to static VLAN, and
ineffective to cluster VLAN, GVRP dynamic VLAN, etc.
2.2.7 Configuring VLAN on the Trunk interface
Configure VLAN on Trunk interface for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
Note