Orion A10E - Checking Configurations; Configuring LLDP Alarm

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
312
Configure basic functions of LLDP for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#lldp
message-transmission
interval period
(Optional) configure the period timer of the
LLDP packet.
3
Alpha-
A28E(config)#lldp
message-transmission
delay period
(Optional) configure the delay timer of the LLDP
packet.
4
Alpha-
A28E(config)#lldp
message-transmission
hold-multiplier hold-
multiplier
(Optional) configure the aging coefficient of the
LLDP packet.
5
Alpha-
A28E(config)#lldp
restart-delay period
(Optional) restart the timer. When configuring the
delay timer and period timer, the value of the
delay timer should be smaller than or equal to a
quarter of the period timer value.
9.4.7 Configuring LLDP alarm
When the network changes, you need to enable LLDP alarm notification function to send
topology update alarm to the NView NNM system immediately.
Configure LLDP alarm for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#snmp-
server lldp-trap
enable
Enable LLDP alarm.
3
Alpha-
A28E(config)#lldp
trap-interval period
(Optional) configure the period timer of LLDP
alarm Trap.
After being enabled with LLDP alarm, the A10E/A28E sends Traps upon detecting
aged neighbours, newly-added neighbours, and changed neighbour information.
9.4.8 Checking configurations
Use the following commands to check configuration results.
Note