Orion A10E - Configuring MVR Interface Information

Orion Networks
A10E/A28E/A28F Configuration Guide
5 Multicast
Orion Networks
129
Step
Configuration
Description
2
Alpha-
A28E(config)#mvr
enable
Enable global MVR.
3
Alpha-
A28E(config)#mvr
timeout period
(Optional) configure the aging time of MVR
multicast entities.
4
Alpha-
A28E(config)#mvr
vlan vlan-id
Configure MVR multicast VLAN.
5
Alpha-
A28E(config)#mvr
vlan vlan-id group
ip-address [ count ]
Configure group address set for multicast VLAN.
The mvr vlan vlan-id group ip-address
[ count ] command is used to configure group
address set for multicast VLAN.
If the received IGMP Report packet does not
belong to group address set of any VLAN, it
is not processed and the user cannot make
multicast traffic on demand.
6
Alpha-
A28E(config)#mvr
mode { compatible |
dynamic }
(Optional) configure MVR operation mode.
Wherein, the dynamic mode allows source
interfaces to dynamically join the multicast group;
the compatible mode does not allow source
interfaces to dynamically join the multicast group.
Only when the receiving interface has a member
which joins the multicast group, the source interface
can join the multicast group.
5.3.4 Configuring MVR interface information
On an aggregating device, configuring immediate leaving is not commended on the
receiving interface. If multiple users are connected to the receiving interface
configured with immediate leaving through another device, the aggregating device
will delete the receiving interface. As a result, other users that are still connected to
the receiving interface fail to receive multicast traffic.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#mvr
enable
Enable global MVR.
3
Alpha-
A28E(config)#interf
ace interface-type
interface-number
Enter physical layer interface configuration mode.