Orion A10E - 1 Basic Configurations; Accessing the Device; Introduction

Orion Networks
A10E/A28E/A28F Configuration Guide
1 Basic configurations
Orion Networks
1
1 Basic configurations
This chapter introduces the basic configuration and configuration process about the
A10E/A28E and provides the related configuration applications, including the following
chapters:

Accessing the device

CLI

Managing users

Managing files

Configuring clock management

Configuring interface management

Configuring basic information

Task scheduling

Watchdog

Load and upgrade
1.1 Accessing the device
1.1.1 Introduction
The A10E/A28E can be configured and managed in Command Line Interface (CLI) mode or
NView NNM network management mode.
The A10E/A28E CLI mode has a variety of configuration modes:

Console mode: it must be used for the first configuration. The A10E/A28E supports the
Console interface of RJ-45 type or USB type.

Telnet mode: log in through the Console mode, open Telnet service on the Switch,
configure Layer 3 interface IP address, set the user name and password, and then take
remote Telnet configuration.

SSHv2 mode: before accessing the A10E/A28E through SSHv2, you need to log in to the
A10E/A28E and start the SSHv2 service through the Console interface.
When configuring the A10E/A28E in network management mode, you must first configure
Layer 3 interface IP address in CLI, and then configure the A10E/A28E through NView NNM
system.