Orion A10E - Configuring Transparent Transmission Parameters; Default Configurations of Layer 2 Protocol Transparent Transmission; Preparing for Configurations

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
67
2.7.2 Preparing for configurations
Scenario
This function enables layer 2 protocol packets of one user network cross through carrier
network to make one user network unified operating one Layer 2 protocol at different region.
You can configure rate limiting on transparent transmission packets to prevent packet loss.
Prerequisite
Configure physical parameters for the interface to set it in Up status before configuring Layer
2 protocol transparent transmission function.
2.7.3 Default configurations of Layer 2 protocol transparent
transmission
The default configuration of Layer 2 protocol transparent transmission is as below.
Function
Default value
Layer 2 protocol transparent transmission status
Disable
Egress interface and belonged VLAN of Layer 2 protocol
packet
NULL
TAG CoS value of transparent transmission packet
5
Destination MAC address of transparent transmission packet
010E.5E00.0003
Discarding threshold and disabling threshold of transparent
transmission packet
NULL
2.7.4 Configuring transparent transmission parameters
Configure transparent transmission parameter for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#relay
destination-address mac-address
(Optional) configure destination MAC
for transparent transmission packet.
The default value is 010E.5E00.0003.
3
Alpha-A28E(config)#relay cos
cos-value
(Optional) configure CoS value for
transparent transmission packet.
4
Alpha-A28E(config)#interface
port port-id
Enter physical layer interface
configuration mode or aggregation
group configuration mode.
5
Alpha-A28E(config-port)#relay
port port-id
Configure specified egress interface
for transparent transmission packet.