A10E/A28E/A28F Configuration Guide
Check whether the A10E/A28E and PC can ping each other by the command of ping.
Alpha-A28E#ping 192.168.1.3
Type CTRL+C to abort
Sending 5, 8-byte ICMP Echos to 192.168.1.3, timeout is 3 seconds:
Reply from 192.168.1.3: time<1ms
Reply from 192.168.1.3: time<1ms
Reply from 192.168.1.3: time<1ms
Reply from 192.168.1.3: time<1ms
Reply from 192.168.1.3: time<1ms
---- PING Statistics----
5 packets transmitted, 5 packets received,
Success rate is 100 percent(5/5),
round-trip (ms) min/avg/max = 0/0/0.
3.3 Default gateway
3.3.1 Introduction
When the packet to be forwarded is not configured with a route, you can configure the default
gateway to enable a device to send the packet to the default gateway. The IP address of the
default gateway should be in the same network segment with the local IP address of the
device.
3.3.2 Preparing for configurations
Scenario
When the packet to be forwarded is not configured with a route, you can configure the default
gateway to enable a device to send the packet to the default gateway.
Prerequisite
Configure the IP address of the switch in advance; otherwise, configuring the default gateway
will fail.
3.3.3 Configuring the default gateway
The IP address of the default gateway should be in the same network segment of any
local IP interface.
Configure the A10E/A28E as below.
To Next Page
Loading...