Orion A10E - Default Configurations of IGMP Filtering; Enabling Global IGMP Filtering; Configuring IGMP Filtering Rules

Orion Networks
A10E/A28E/A28F Configuration Guide
5 Multicast
Orion Networks
133
Prerequisite

Enable MVR.

Configure multicast VLAN and group address set.

Configure the source interface and receiving interfaces, and add the related interfaces to
the responding VLANs.
5.5.2 Default configurations of IGMP filtering
Function
Default value
Global IGMP filtering
Disable
IGMP filter profile Profile
None
IGMP filter profile action
Refuse
IGMP filtering under interface
No maximum group limitation. The largest group
action is drop, and no application filter profile.
IGMP filtering under
interface+VLAN
No maximum group limitation. The largest group
action is drop, and no application filter profile.
5.5.3 Enabling global IGMP filtering
Enable global IGMP filtering as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode
2
Alpha-A28E(config)#igmp filter
Enable global IGMP filtering
Before configuring IGMP filter profile or the maximum group limitation, use the igmp
filter command to enable global IGMP filtering.
5.5.4 Configuring IGMP filtering rules
Configure IGMP filter profile as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode
2
Alpha-A28E(config)#ip igmp
profile profile-number
Create an IGMP profile, and enter profile
configuration mode.
3
Alpha-A28E(config-igmp-
profile)#{ permit | deny }
Configure IGMP profile action.