A10E/A28E/A28F Configuration Guide
Alpha-A28E#hostname SwitchA
SwitchA#config
SwitchA(config)#oam active
SwitchA(config)#interface port 1
SwitchA(config-port)#oam enable
SwitchA(config-port)#oam event trap enable
SwitchA(config-port)#oam peer event trap enable
Step 2 Configure Switch B.
Alpha-A28E#hostname SwitchB
SwitchB#config
SwitchB(config)#interface port 1
SwitchB(config-port)#oam enable
Checking results
Show EFM configurations on Switch A by the command of show oam.
SwitchA#show oam port-list 1
Port: 1
Mode:Active
Administrate state: Enable
Operation state: Operational
Max OAMPDU size: 1518
Send period: 1000 ms
Link timeout : 5 s
Config revision: 1
Supported functions: Loopback, Event, Variable
Show OAM event alarm configurations on Switch A by the command of show oam trap.
SwitchA#show oam trap port-list 1
Port: 1
Event trap: Enable
Peer event trap: Enable
Discovery trap total: 0
Discovery trap timestamp: 0 days, 0 hours, 0 minutes
Lost trap total: 0
Lost trap timestamp: 0 days, 0 hours, 0 minutes
8.2 CFM