Orion A10E - Checking Configurations

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
295
Step
Configuration
Description
3
Alpha-A28E(config-ip)#ip
address ip-address [ ip-
mask ] vlan-list
Configure the IP address of the Layer 3
interface.
4
Alpha-A28E(config-ip)#exit
Exit from global configuration and enter
privileged EXEC mode.
5
Alpha-A28E(config)#snmp-
server host ip-address
version 3 { authnopriv |
noauthnopriv } user - name
[ udpport port-id ]
(Optional) configure SNMP v3-based Trap
target host.
Alpha-A28E(config)#snmp-
server host ip-address
version { 1 | 2c } com -
name [ udpport udpport ]
(Optional) configure SNMP v1-/SNMP v2c-
based Trap target host.
6
Alpha-A28E(config)#snmp-
server enable traps
Enable Trap.
9.1.8 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show
snmp access
Show SNMP access group configurations.
2
Alpha-A28E#show
snmp community
Show SNMP community configurations.
3
Alpha-A28E#show
snmp config
Show SNMP basic configurations, including local
SNMP engine ID, ID and contact of the network
management personnel, device location, and Trap switch
status.
4
Alpha-A28E#show
snmp group
Show the mapping relationship between SNMP users
and the access group.
5
Alpha-A28E#show
snmp host
Show Trap target host information.
6
Alpha-A28E#show
snmp statistics
Show SNMP statistics.
7
Alpha-A28E#show
snmp user
Show SNMP user information.
8
Alpha-A28E#show
snmp view
Show SNMP view information.
9
Alpha-A28E#show
snmp trap remote
Show remote Trap configurations of SNMP.