Orion A10E - Configure Extended OAM Protocols; Default Configurations of Extended OAM; Establishing OAM Link

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
318
Prerequisite
You need to complete the following tasks before configure extended OAM:

Establish OAM link between devices to establish extended OAM link.
The following configurations take A10E/A28E as the CO device. For different remote devices,
the extended OAM networking situation and configuration commands may be different;
please take configuration according to the specific remote networking situation.
9.5.3 Default configurations of extended OAM
The default configuration of extended OAM is as below.
Function
Default value
OAM function status
Disable
OAM working mode
passive
Remote Trap function status
Enable
9.5.4 Establishing OAM link
You need to establish OAM link between devices to establish extended OAM link and
both sides of devices are OAM active mode and passive mode respectively.
Establish OAM link on CO device and remote device as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#oam
{ active | passive }
Configure OAM working mode.
Establish both sides of OAM link; configure
CO device as active mode and remote device
as passive mode.
3
Alpha-
A28E(config)#interface
interface-type
interface-number
Enter physical layer interface configuration
mode.
4
Alpha-A28E(config-
port)#oam enable
Enable interface OAM function.
9.5.5 Configure extended OAM protocols
Configure the A10E/A28E as below.