A10E/A28E/A28F Configuration Guide
Alpha-A28E(config-igmp-
profile)#range
start-ip-
address
[
end-ip-address
]
Configure the IP multicast address or range
to be controlled for access.
5.5.5 Applying IGMP filtering rules
Configure IGMP filter profile as below.
Enter global configuration mode
Alpha-
A28E(config)#interface
port
port-id
Enter physical layer interface configuration
mode.
Alpha-A28E(config-port)#ip
igmp filter
profile-number
(Optional) applying IGMP profile filtering
rules on the interface.
An IGMP profile can be applied to multiple
interfaces, but each interface can be
configured with only one IGMP profile.
Alpha-A28E(config-
port)#exit
Alpha-A28E(config)#ip igmp
filter
profile-number
vlan
vlan-id
(Optional) applying IGMP profile filtering
rules in the VLAN.
5.5.6 Configuring the maximum multicast group number
You can add the maximum multicast group number applied to interface or interface+VLAN.
Configuring the maximum multicast group number on the interface
Configure the A10E/A28E as below.
Enter global configuration mode
Alpha-
A28E(config)#interface
interface-type interface-
number
Enter physical layer interface configuration
mode.
Alpha-A28E(config-port)#ip
igmp max-groups
group-
number
Configure the maximum multicast group
number allowed on the interface.
Alpha-A28E(config-port)#ip
igmp max-groups action
{ deny | replace }
(Optional) configure the action when the
number of groups exceeds the maximum
multicast group number allowed on the
interface.
To Next Page
Loading...