A10E/A28E/A28F Configuration Guide
9.5.10 Configuring the IP address of the remote device
Whether the remote device supports this function varies with the specific remote
device. For details, see the corresponding manuals.
Configure the remote device as below.
Enter global configuration mode.
Alpha-
A28E(config)#interface
interface-type
interface-number
Enter physical layer interface configuration
mode.
Alpha-A28E(config-
port)#remote-device
Enter remote configuration mode.
Alpha-A28E(config-
remote)#ip address
ip-
address
[
ip-mask
]
vlan-list
Configure remote device IP address.
Set the IP address of IP interface 0 on the
remote device to take effect.
IP address configuration needs to specify
management VLAN, if this VLAN does not
exist, create VLAN and take all interfaces as
member interface by default; if associated
VLAN exists, do not modify the member
interface configuration.
Alpha-A28E(config-
remote)#ip default-
gateway
ip-address
(Optional) configure remote device default
gateway. The default gateway and
configured IP address of IP interface 0 need
to be in the same network segment.
9.5.11 Configuring interface parameters on the remote device
Whether the remote device supports this function varies with the specific remote
device. For details, see the corresponding manuals.
Configure different remote interface parameters in different mode:
In remote interface configuration mode, configure remote interface Up/Down, speed and
working mode, etc.
In remote configuration mode, configure remote interface auto-negotiation, interface
bandwidth, and failover, etc.
Configuring interface parameters in remote interface configuration mode
In remote interface configuration mode, configure remote interface Up/Down, speed and
working mode, etc.
To Next Page
Loading...