Orion A10E - Command Line Level; Command Line Mode

Orion Networks
A10E/A28E/A28F Configuration Guide
1 Basic configurations
Orion Networks
7

Local or remote configuration via Telnet, Secure Shell v2 (SSHv2) is available.

Protection for different command levels, users in different level can only execute
commands in related level.

Different command types belong to different command modes. You can only execute a
type of configuration in its related command mode.

You can operate the commands by shortcut keys.

You can view or execute a historical command by transferring history record. The
A10E/A28E supports saving the latest 20 historical commands.

Online help is available by inputting "?" at any time.

Smart analysis methods such as incomplete matching and context association, etc.
facilitate user input.
1.2.2 Command line level
The A10E/A28E uses hierarchy protection methods to divide command line into 16 levels
from low to high.

0–4: visitor, users can execute the commands of ping, clear, and history, etc. in this
level;

5–10: monitor, users can execute the command of show and so on;

11–14: operator, users can execute commands for different services like VLAN, IP, etc.;

15: administrator, used for system basic running commands.
1.2.3 Command line mode
Command line mode is the CLI environment. All system commands are registered in one (or
some) command line mode, the command can only run under the corresponding mode.
Establish a connection with the A10E/A28E. If the A10E/A28E is in default configuration, it
will enter user EXEC mode, and the screen will display:
Alpha-A28E>
Input the enable command and correct password, and then enter privileged EXEC mode. The
default password is admin.
Alpha-A28E>enable
Password:
Alpha-A28E#
In privileged EXEC mode, input the command of config terminal to enter global
configuration mode.
Alpha-A28E#config terminal
Alpha-A28E(config)#