Orion A10E - Checking Configuration; Example for Configuring Ethernet Ring; Maintenance; Figure 7-17 RRPS Application Networking

Orion Networks
A10E/A28E/A28F Configuration Guide
7 Reliability
Orion Networks
259
7.7.6 Checking configuration
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show ethernet
ring [ ring-id ]
Show RRPS information.
2
Alpha-A28E#show ethernet
ring port
Show RRPS interface information.
3
Alpha-A28E#show ethernet
ring port statistic
Show statistics of RRPS interface packets.
7.7.7 Maintenance
Command
Description
Alpha-A28E(config)#clear
ethernet ring ring-id
statistics
Clear RRPS interface statistics, including RRPS
ID, ring interface ID, Hello packet, Change
packet, and Flush packet.
7.7.8 Example for configuring Ethernet ring
Networking requirements
As shown below, to improve the reliability of Ethernet, the Switch A, Switch B, Switch C,
Switch D have constituted an Ethernet single ring Ring 1.
The figure shows that the four switches are added to Ring 1 interface. MAC addresses are
Switch A (000E.5E00.000A), Switch B (000E.5E00.000B), Switch C (000E.5E00.000C), and
Switch D (000E.5E00.000D).
The status and priority of four nodes are the same, MAC address of Switch D is biggest, and
therefore, Switch D is the master node of RRPS.
Figure 7-17 RRPS application networking