Orion A10E - Checking Configurations; Configuring Rate Limiting Based on Qinq; Configuring Rate Limiting Based on VLAN; Maintenance

Orion Networks
A10E/A28E/A28F Configuration Guide
4 QoS
Orion Networks
114
4.6.3 Configuring rate limiting based on VLAN
Configure rate limiting based on VLAN on the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#rate-limit
vlan vlan-id rate-value burst-
value [ statistics ]
(Optional) configure rate limiting
based on VLAN.
4.6.4 Configuring rate limiting based on QinQ
Configure rate limiting based on QinQ on the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#rate-limit
double-tagging-vlan outer { outer-
vlan-id | any } inner { inner-vlan-
id | any } rate-value burst-value
[ statistics ]
(Optional) configure rate limiting
based on QinQ.
4.6.5 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show rate-limit port-
list [ port-list ]
Show configurations of rate
limiting on specified interfaces.
2
Alpha-A28E#show rate-limit vlan
Show configurations of rate
limiting based on VLAN.
4.6.6 Maintenance
Maintain the A10E/A28E as below.
Command
Description
Alpha-A28E(config)#clear rate-limit
statistics vlan [ vlan-id ]
Clear statistics of packet lost due to
rate limiting based on VLAN.