Orion A10E - Managing Remote Configuration Files

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
329
Step
Configuration
Description
6
Alpha-A28E(config-
remote)#switch-mode
double-tagged-vlan [ tpid
tpid ] native-vlan vlan-id
[ line ]
(Optional) configure remote device to work
in double Tag forwarding mode.

To configure remote device to work in full transparent transmission mode, do not
deal with data packets.

To configure remote device to work in single Tag mode, after the A10E/A28E is
configured to single Tag mode, the data packets without Tag from user interface
will be marked with Tag with local VLAN ID; do nothing if there is Tag.

To configure remote device to work in double Tag mode, after the A10E/A28E is
configured to double Tag mode, the data packets without Tag from user interface
will be marked with outer Tag with specified TPID and local VLAN ID.
9.5.16 Managing remote configuration files
Whether the remote device supports this function varies with the specific remote
device. For details, see the corresponding manuals.
Configure the CO device as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#interface
port port-id
Enter physical layer interface configuration
mode.
3
Alpha-A28E(config-
port)#remote-device
Enter remote configuration mode.
4
Alpha-A28E(config-
remote)#write
(Optional) save remote device configuration
files in remote device flash.
5
Alpha-A28E(config-
remote)#write local
(Optional) save remote device configuration
files in CO device flash.
6
Alpha-A28E(config-
remote)#erase
(Optional) delete remote device configuration
files.