Orion A10E - Figure 8-2 Configuring EFM; Maintenance; Example for Configuring EFM

Orion Networks
A10E/A28E/A28F Configuration Guide
8 OAM
Orion Networks
269
Step
Configuration
Description
2
Alpha-A28E#show oam loopback
[ port-list port-list ]
Show EFM remote loopback
configurations.
3
Alpha-A28E#show oam notify
[ port-list port-list ]
Show OAM link monitoring and fault
indication configurations.
4
Alpha-A28E#show oam
statistics [ port-list port-
list ]
Show OAM statistics.
5
Alpha-A28E#show oam trap
[ port-list port-list ]
Show OAM event alarm
configurations.
6
Alpha-A28E#show oam event
[ port-list port-list ]
[ critical ]
Show information about local critical
faults detected on an interface.
7
Alpha-A28E#show oam peer
event [ port-list port-list ]
[ critical ]
Show information about critical faults
sent by the peer.
8.1.8 Maintenance
You can maintain the EFM feature through the below command.
Command
Description
Alpha-A28E(config-port)#clear oam
statistics
Clear EFM OAM interface link statistics.
Alpha-A28E(config-port)#clear oam
event
Clear EFM OAM interface link event
information.
8.1.9 Example for configuring EFM
Networking requirements
As shown in Figure 8-2, to improve the management and maintenance capability of the
Ethernet link between Switch A and Switch B, you need to deploy EFM on Switch A. Switch
A works in active mode and is deployed with OAM event alarm function.
Figure 8-2 Configuring EFM
Configuration steps
Step 1 Configure Switch A.