Orion A10E - Accessing from Telnet; Figure 1-3 Networking with the A10 E;A28 E as Telnet Server; Figure 1-2 Communication Parameters Configuration in Hyper Terminal; Mouse Operation

Orion Networks
A10E/A28E/A28F Configuration Guide
1 Basic configurations
Orion Networks
3
Figure 1-2 Communication parameters configuration in Hyper Terminal
Microsoft is not in support of Hyper Terminal since Windows Vista system. For
Windows Vista or Windows 7, download Hyper Terminal program from internet. It is
free to download HyperTerminal program.
1.1.3 Accessing from Telnet
You can use a PC to log in to the A10E/A28E remotely through Telnet. You can log in to an
A10E/A28E from PC at first, then Telnet other A10E/A28E devices on the network. You do
not need to connect a PC to each A10E/A28E.
Telnet service provided by the A10E/A28E includes:

Telnet Server: run the Telnet client program on a PC to log in to the A10E/A28E, and
take configuration and management. As shown in Figure 1-3, the A10E/A28E is
providing Telnet Server service at this time.
Figure 1-3 Networking with the A10E/A28E as Telnet server
Before accessing the A10E/A28E through Telnet, you need to log in to the A10E/A28E
through the Console interface and start the Telnet service. Take the following configurations
on the A10E/A28E that needs to start Telnet service.
Note