Orion A10E - Checking Configurations; Example for Configuring Secure MAC Address; Maintenance

Orion Networks
A10E/A28E/A28F Configuration Guide
6 Security
Orion Networks
157
Step
Configuration
Description
5
Alpha-A28E(config-
port)#switchport port-security
mac-address sticky
(Optional) manually configure
Sticky secure MAC addresses.
After Sticky port secure MAC
learning is enabled, dynamic
security port AMC is
translated into the Sticky MAC
address. Manually configured
Sticky security MAC address
takes effect.
6.2.8 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show port-
security [ port-list port-
list ]
Show interface configurations of port
security MAC.
2
Alpha-A28E#show port-
security mac-address [ port-
list port-list ]
Show secure MAC address
configuration and secure MAC address
learning configurations.
6.2.9 Maintenance
Maintain the A10E/A28E as below.
Command
Description
Alpha-A28E(config-port)#clear
port-security { all | configured |
dynamic | sticky }
Clear a specified secure MAC address type
on a specified interface.
6.2.10 Example for configuring secure MAC address
Networking requirements
As shown below, the switch connects 3 user networks. To ensure the security of switch
interface access data, the configuration is as below.

Port 1 permits 3 users to access network at most. The MAC address of one user is
specified to 0000.0000.0001. The other 2 users dynamically learn the MAC addresses;
the NView NNM system will receive Trap information once the user learns a MAC
address. Violation mode is set to Protect and the aging time of the two learned MAC
addresses is set 10min.
Note