Orion A10E - Configuring Basic CFM Functions; Enabling CFM

Orion Networks
A10E/A28E/A28F Configuration Guide
8 OAM
Orion Networks
274
8.2.4 Enabling CFM
Configure CFM for the A10E/A28E as below.
CFM fault detection, location function cannot take effect unless enables CFM function
on the A10E/A28E.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#ethernet
cfm enable
Enable global CFM function.
3
Alpha-
A28E(config)#interface
port port-id
Enter physical layer interface configuration
mode.
4
Alpha-A28E(config-
port)#ethernet cfm
enable
Enable CFM on interface.
Use the ethernet cfm disable command to
disable this function. After it is disabled, the
interface cannot receive or send CFM packets.
8.2.5 Configuring basic CFM functions
Configure CFM for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-
A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#e
thernet cfm
domain [ md-
name domain-
name ] level
level
Create maintain domain. Use the parameter md-name to
assign name for MD in 802.1ag style. MA and CCM
packets under MD are both in 802.1ag style; do not assign
name, the MD is in Y.1731 style, MA and CCM packets
under this MD are both in Y.1731 style. If user assigns
name for MD, the name must be unique in global, or else
MD configuration will be failure.
Level of different MD must be different; otherwise
MD configuration will fail.
3
Alpha-
A28E(config)#s
ervice cisid
level level
Create service instance and enter instance configuration
mode (MD name, service instance name). Character string
is unique in global range. If service instance existed, this
command will direct lead to service instance configuration
mode.