Orion A10E - Example for Configuring Rate Limiting Based on Interface; Figure 4-9 Rate Limiting Based on Interface

Orion Networks
A10E/A28E/A28F Configuration Guide
4 QoS
Orion Networks
117
4.7.2 Example for configuring rate limiting based on interface
Networking requirements
As shown below, User A, User B, User C are respectively connected to Switch A, Switch B,
Switch C and A10E/A28E.
User A requires voice and video services, User B requires voice, video and data services, User
C requires video and data services.
According to service requirements, user needs to make rules as below.

For User A, provide 25 Mbit/s assured bandwidth, permitting burst flow 100 KB and
discarding redundant flow;

For User B, provide 35 Mbit/s assured bandwidth, permitting burst flow 100 KB and
discarding redundant flow;

For User C, provide 30 Mbit/s assured bandwidth, permitting burst flow 100 KB and
discarding redundant flow.
Figure 4-9 Rate limiting based on interface
Configuration steps
Step 1 Configure rate limiting based on interface.
Alpha-A28E#config
Alpha-A28E(config)#rate-limit port-list 2 ingress 25000 100
Alpha-A28E(config)#rate-limit port-list 3 ingress 35000 100
Alpha-A28E(config)#rate-limit port-list 4 ingress 30000 100