Orion A10E - Checking Configurations; Configuring Interface Protection; Default Configurations of Interface Protection; Preparing for Configurations

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
59
2.5.2 Preparing for configurations
Scenario
To isolate Layer 2 data from the interfaces in the same VLAN, like physical isolation, you
need to configure interface protection.
The interface protection function can realize mutual isolation of the interfaces in the same
VLAN, enhance network security and provide flexible networking solutions for you.
Prerequisite
N/A
2.5.3 Default configurations of interface protection
The default configuration for interface protection is as below.
Function
Default value
Interface protection function status of each interface
Disable
2.5.4 Configuring interface protection
Configure interface protection for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#interface
port port-id
Enter physical layer interface
configuration mode.
3
Alpha-A28E(config-
port)#switchport protect
Enable interface protection.
2.5.5 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show switchport
protect
Show interface protection
configuration.