Orion A10E - Configuring MVR; Preparing for Configurations; Default Configurations of MVR; Configuring MVR Basic Information

Orion Networks
A10E/A28E/A28F Configuration Guide
5 Multicast
Orion Networks
128
No.
Item
Description
2
Alpha-A28E#show ip igmp
snooping mrouter [ vlan vlan -
id ]
Show information about multicast
router interface of IGMP Snooping.
3
Alpha-A28E#show mac-address-
table multicast [ vlan vlan-
id ] [ count ]
Show information about Layer 2
multicast MAC address table.
5.3 Configuring MVR
5.3.1 Preparing for configurations
Scenario
Multiple hosts receive data from the multicast sources. These hosts and the multicast router
belong to different VLANs. Enable MVR on Switch A, and configure multicast VLAN. In this
way, users in different VLANs can share a multicast VLAN to receive the same multicast data,
and reduce bandwidth waste.
Prerequisite
Create VLANs and add related interfaces to VLANs.
5.3.2 Default configurations of MVR
Function
Default value
Global MVR status
Disable
Interface MVR status
Disable
Multicast VLAN and group address set
None
MVR multicast entity aging time
600s
MVR operation mode
Dynamic
MVR interface immediate leaving status
Disable
5.3.3 Configuring MVR basic information
Configure the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.