A10E/A28E/A28F Configuration Guide
4.3.10 Checking configurations
Use the following commands to check configuration results.
Alpha-A28E#show service-policy
statistics [
port
port-id
]
Show traffic policy function status
and the applied policy statistics.
Alpha-A28E#show class-map [
class-
map-name
]
Show traffic classification
information.
Alpha-A28E#show policy-map
[
policy-map-name
]
Show traffic policy information.
Alpha-A28E#show policy-map
[
policy-map-name
] [ class
class-
map-name
]
Show traffic classification
information in traffic policy.
Alpha-A28E#show mls qos policer
[
policer-name
]
Show assigned token bucket (rate
limiting and shaping) information.
Alpha-A28E#show mls qos policer
[ aggregate-policer | class-policer
| single-policer ]
Show assigned type token bucket
(rate limiting and shaping)
information.
Alpha-A28E#show policy-map port
[
port-id
]
Show traffic policy application
information on the interface.
Alpha-A28E#show mls qos queue-rate
[ port-list
port-list
]
Show rate limiting on the
interface.
4.3.11 Maintenance
Alpha-A28E(config)#clear service-policy statistics
[ egress
port-id
[ class-map
class-map-name
] | ingress
port-id
[ class-map
class-map-name
] | port
port-id
]
Clear statistics
of QoS packets.
4.4 Configuring priority mapping
4.4.1 Preparing for configurations
Scenario
You can choose priority for trusted packets from upstream device, untrusted priority packets
are processed by traffic classification and traffic policy. After configuring priority trust mode,
the A10E/A28E operates packets according to their priorities and provides related service.
To Next Page
Loading...