Orion A10E - Default Configurations of Optical Module DDM; Introduction; Optical Module DDM; Preparing for Configurations

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
333
Community Name/Access: N/A/N/A
OAM Notification:
Device current temperature(Celsius): 0(Celsius)
Device voltage: low
Ref. Volt(mv) Current Volt(mv)
3300 0l
2500 0l
1800 0l
1200 0l
9.6 Optical module DDM
9.6.1 Introduction
Digital Diagnostic Monitoring (DDM) on the A10E/A28E supports diagnosing the Small
Form-factor Pluggable (SFP) module.
SFP DDM provides a method for monitoring performance. By analyzing monitored data
provides by the SFP module, the administrator can predict the lifetime for the SFP module,
isolate system faults, as well as verify the compatibility of the SFP module.
The SFP module offers 5 performance parameters:

Module temperature

Internal Power Feeding Voltage (PFV)

Launched bias current

Launched optical power

Received optical power
When SFP performance parameters exceed thresholds or when SFP state changes, related
Trap is generated.
9.6.2 Preparing for configurations
Scenario
SFP DDM provides a method for monitoring performance parameters of the SFP module. By
analyzing monitored data, you can predict the lifetime for the SFP module, isolate system
faults, as well as verify the compatibility of the SFP module.
Prerequisite
N/A
9.6.3 Default configurations of optical module DDM
The default configuration of optical module DDM is as below.