Orion A10E - Default Configurations of CFM

Orion Networks
A10E/A28E/A28F Configuration Guide
8 OAM
Orion Networks
273
if source MEP received LBR the path is connective, if source MEP does not receive LBR
the path is not connective.

Fault location function (LT, LinkTrace)
Source MEP sends LTM (LinkTrace Packet) to destination MP, each MP device on LTM
transmitting path answers LTR (LinkTrace Reply) to source MEP, the function records
efficient LTR and LTM fault location point.
Anyway, CFM implements end-to-end service OAM technology, reducing carriers' operation
cost and improving competitiveness.
Prerequisite

Connect the interface and configure physical parameters for it to make it physically Up.

Create VLANs.

Add interfaces into VLANs.
8.2.3 Default configurations of CFM
Function
Default value
Global CFM function status
Disable
CFM function status on interface
Enable
MEP status based on service instance
Up direction
Aging time of RMEP
100min
Storage time of error CCM packet
100min
MEP sending CCM packet status
Not send
MEP sending CCM packet mode
Passive mode
CCM packet sending interval
1s
Dynamic import function of service instance
RMEP learning
Not take effect
cc check function of RMEP
Disable
Priority of CFM OAM packet
6
Layer-2 ping function status
The number of sending LBM packets
is 5; the length of packet TLV is 64.
Switch status of fault location data base
Disable
Storage time of fault location data base
100min
Alarm suppression function status
Enable