Orion A10E - Configuring Interface Statistics; Enabling;Disabling Interfaces; Checking Configurations

Orion Networks
A10E/A28E/A28F Configuration Guide
1 Basic configurations
Orion Networks
25
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#interface port
port-id
Enter physical layer interface configuration
mode.
3
Alpha-A28E(config-port)#sfp
detect-mode { auto-detect |
force-100base-x | force-
1000base-x }
Configure SFP interface detection mode.
Non-SFP interfaces cannot be configured
with detection mode.
1.6.6 Configuring interface statistics
Configure the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#dynamic
statistics time period
Configure period for interface dynamic
statistics.
By default, it is 2s.
3
Alpha-A28E(config)#clear
interface port port-id
statistics
Clear interface statistics saved on the
A10E/A28E.
1.6.7 Enabling/Disabling interfaces
Configure the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#interface
port port-id
Enter physical layer interface
configuration mode.
3
Alpha-A28E(config-
port)#shutdown
Disable current interface.
Use the command of no shutdown to re-
open the closed interface.
1.6.8 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show interface port [ port-
id ]
Show interface status.