Orion A10E - Checking Configurations; Configuring RADIUS Accounting

Orion Networks
A10E/A28E/A28F Configuration Guide
6 Security
Orion Networks
168
6.4.5 Configuring RADIUS accounting
Configure RADIUS accounting for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#interface ip
if-number
Enter Layer 3 interface configuration
mode.
3
Alpha-A28E(config-ip)#ip
address ip-address [ sub ]
[ ip-mask ] [ vlan-list ]
Configure an IPv4 address.
4
Alpha-A28E(config-ip)#end
Return to privileged EXEC mode.
5
Alpha-A28E#aaa accounting
login enable
Enable RADIUS accounting.
6
Alpha-A28E#radius
[ backup ] accounting-
server ip-address
[ account-port ]
Assign IP address and UDP port ID for
RADIUS accounting server.
7
Alpha-A28E#radius
accounting-server key
string
Configure the shared key to communicate
with the RADIUS accounting server. The
shared key must be identical to the one
configured on the RADIUS accounting
server. Otherwise, accounting fails.
8
Alpha-A28E#aaa accounting
fail { offline | online }
Configure the processing policy for
accounting failure.
9
Alpha-A28E#aaa accounting
update period
Configure the period for sending
accounting update packets. If configured as
0, no accounting update packet is sent.
The RADIUS accounting server can
record access time and operation for
each user through accounting
starting packets, update packets and
accounting end packets.
6.4.6 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show
radius-server
Show configurations on the RADIUS server.
2
Alpha-A28E#show aaa
accounting
Show configurations of global accounting.
Note