A10E/A28E/A28F Configuration Guide
Alpha-A28E(config-
remote)#line-speed auto
(Optional) configure rate auto-negotiation on
the Line interface of the remote device.
You can configure the optical interface with
auto-negotiation when the interface connecting
remote device and CO device is 1000 Mbit/s
optical port.
Alpha-A28E(config-
remote)#rate-limit
interface-type
interface-number
ingress
rate
(Optional) configure remote ingress interface
bandwidth.
Alpha-A28E(config-
remote)#fault-pass
enable
(Optional) enable remote failover.
The fault optical interface on the remote device
changes to electrical port after being enabled
with remote failover.
Alpha-A28E(config-
remote)#inside-loopback
[ crc-recalculate ]
(Optional) enable inner loopback on the optical
interface on the remote device.
Alpha-A28E(config-
remote)#test cable-
diagnostics
Conduct virtual line detection on the remote
device.
For the above interface configuration in remote configuration mode:
If the command line provides specified interface parameters, the corresponding
configuration will take effect on specified interface;
If the command line does not provide specified interface parameters, the
corresponding configuration will take effect on all interfaces of the corresponding
type on the remote device.
9.5.12 Uploading and downloading files on the remote device
Downloading files from the server to the remote device
The system bootstrap file, system startup file, configuration files, and FPGA file can be
forwarded from the CO device to the remote device, which can be initiated by the CO device
or the remote device. If the CO device initiates this, it can upgrade multiple remote devices.
On the CO device, download files from the FTP/TFTP server to the remote device as below.
Enter global configuration mode.
Alpha-A28E(config)#interface
interface-type interface-
number
Enter physical layer interface
configuration mode.
Alpha-A28E(config-
port)#remote-device
Enter remote configuration mode.
To Next Page
Loading...