A10E/A28E/A28F Configuration Guide
Configure Switch A.
SwitchA(config)#trunk enable
Configure Switch B.
SwitchB(config)#trunk enable
Checking results
Show global configurations on manual link aggregation by the command of show trunk.
SwitchA#show trunk
Trunk: Enable
Loading sharing mode: SMAC
Trunk Group Mode Member Ports Efficient Ports
-----------------------------------------------------------
1 manual 1,2 1,2
7.1.8 Example for configuring static LACP link aggregation
Networking requirements
As shown in Figure 7-2, to improve link reliability between Switch A and Switch B, you can
configure a static LACP link aggregation between these 2 devices. Add Port 1 and Port 2 into
one link aggregation group, where Port 1 is used as the current link and Port 2 is the
protection link.
Figure 7-2 Configuring static LACP link aggregation
To Next Page
Loading...