Orion A10E - Figure 9-11 Extended OAM Application Networking; Extended OAM; Introduction

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
316
LLDP enable status: enable (default is disabled)
LLDP enable ports: 1
LldpMsgTxInterval: 60 (default is 30s)
LldpMsgTxHoldMultiplier: 4 (default is 4)
LldpReinitDelay: 2 (default is 2s)
LldpTxDelay: 9 (default is 2s)
LldpNotificationInterval: 10 (default is 5s)
LldpNotificationEnable: enable (default is enabled)
Show LLDP neighbour information by the command of show lldp remote.
SwitchA#show lldp remote
Port ChassisId PortId SysName MgtAddress ExpiredTime
-------------------------------------------------------------------------
port1 000E.5E02.B010 port 1 SwitchB 10.10.10.2 106
……
SwitchB#show lldp remote
Port ChassisId PortId SysName MgtAddress ExpiredTime
-------------------------------------------------------------------------
port1 000E.5E12.F120 port 1 SwitchA 10.10.10.1 106
9.5 Extended OAM
9.5.1 Introduction
Extended OAM is based on IEEE 802.3ah OAM links. Based on standard OAM extendibility,
it enhances OAM functions, including remote configurations and monitoring.
As shown in Figure 9-11, establish an extended OAM link between the remote switch A and
Central Office (CO) Switch B directly connected to the NView NNM system, to enable
Switch B to manage Switch A.
Figure 9-11 Extended OAM application networking