Orion A10E - Configuring Basic Qinq; Configuring Selective Qinq; Default Configurations of Qinq; Preparing for Configurations

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
47
Tag and configure data transmission priority flexibly so as to make users in different class
receive the corresponding services.
2.3.2 Preparing for configurations
Scenario
With application of basic QinQ, you can add outer VLAN Tag to plan Private VLAN ID
freely so as to make the user device data at both ends of carrier network take transparent
transmission without conflicting with VLAN ID in service provider network.
Prerequisite

Connect the interface and configure interface physical parameters to make the physical
status Up.

Create VLANs.
2.3.3 Default configurations of QinQ
The default configuration of QinQ is as below.
Function
Default value
Outer Tag TPID
0x8100
Basic QinQ status
Disable
2.3.4 Configuring basic QinQ
Configure basic QinQ on the ingress interface as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration
mode.
2
Alpha-A28E(config)#mls double-tagging
tpid tpid
(Optional) configure TPID.
3
Alpha-A28E(config)#interface port
port-id
Enter physical layer interface
configuration mode.
4
Alpha-A28E(config-port)#switchport
qinq dot1q-tunnel
Enable basic QinQ on the
interface.
2.3.5 Configuring selective QinQ
Configure selective QinQ on the ingress interface as below.