A10E/A28E/A28F Configuration Guide
Alpha-
A28E(config-
service)#servi
ce vlan-list
vlan-list
Configure service application VLAN map.
VLAN list permits at most 32 VLAN. The smallest VLAN
will be taken as primary VLAN of service instance. All
MEP in service instance transmit and receive packets
through primary VLAN.
Since using primary VLAN to transmit and receive
packets, all of other VLAN in the list are mapped to
primary VLAN. This logical VLAN mapping
relationship is globally; VLAN mapping relationship
of different level can be identical but cannot
crossover. For example: instance 1 mapping to
VLAN 10-20, instance 2 mapping to VLANs 15-30,
the configuration is illegal because VLANs 15-20
are crossed.
Alpha-
A28E(config-
service)#servi
ce mep [ up |
down ] mpid
mep-id
port
port
-
id
Configure MEP over service instance.
Service instance must map to VLAN when configuring this
kind MEP. By default, MEP is Up direction, namely
interface uplink direction detects fault.
8.2.6 Configuring fault detection
Configure CFM fault detection on the A10E/A28E as below.
Enter global configuration mode.
Alpha-
A28E(config)#ethernet
cfm remote mep age-
time
minute
(Optional) configure RMEP aging time.
Alpha-
A28E(config)#ethernet
cfm errors archive-
hold-time
minute
(Optional) configure hold time for error CCM
packets. The A10E/A28E saves all fault
information of reported by MEP.
By default, hold time for error CCM packets is
100 minutes. It check data in database once
system configures new hold time, clear data
immediately if there is data over time.
Alpha-
A28E(config)#ethernet
cfm mode { slave |
master }
Configure the mode for all service instances to
send CCM packets.
Alpha-
A28E(config)#service
cisid
level
level
Enter service instance configuration mode.
To Next Page
Loading...