Orion A10E - Page 296

Orion Networks
A10E/A28E/A28F Configuration Guide
8 OAM
Orion Networks
276
Step
Configuration
Description
6
Alpha-A28E(config-
service)#service cc
interval { 1 | 10 |
100ms | 60 | 600 }
(Optional) configure service instance CCM
packets sending time interval. By default, CCM
packets sending time interval is 10 seconds.
Cannot modify CCM packets sending interval
when CCM packets sending function enable.
7
Alpha-A28E(config-
service)#service cc
enable mep { mep-list
| all }
Enable MEP sending CCM packets. By default,
MEP does not send CCM packet.
8
Alpha-A28E(config-
service)#service
remote-mep mep-list
(Optional) configure static RMEP. Used
cooperated with cc check function.
9
Alpha-A28E(config-
service)#service
remote-mep learning
active
(Optional) configure RMEP learning dynamic
import function. Service instance transfer
dynamic RMEP to static RMEP by automation
every time receiving of CCM packets. By default,
this function does not take effective.
10
Alpha-A28E(config-
service)#service
remote-mep cc-check
enable
(Optional) configure RMEP cc check function.
After this function is enabled, system checks
dynamic learned RMEP ID consistent with static
RMEP ID when receiving CCM packets, if not
consistent, the CCM packets are considered as
incorrect.
11
Alpha-A28E(config-
service)#service
cvlan vlan-id
(Optional) configure client VLAN of CFM OAM
packets, just need configure in QinQ networking
environment. By default, CFM OAM packets do
not take C-TAG. After configuring client VLAN
for service instance, all MEP under the instance
send CCM, LTM, LBM, DMM with double
TAG. Hereinto, C-TAG uses this command to
configure client VLAN.
12
Alpha-A28E(config-
service)#service
priority priority
(Optional) configure CFM OAM packets priority.
After configuring packets priority, all CCM,
LBM, LTM, DMM sent by MEP use assigned
priority.