A10E/A28E/A28F Configuration Guide
Alpha-A28E#upload system
[ master | slave ] { ftp
ip-
address user-name password file-
name
| sftp
ip-address user-name
password file-name
| tftp
ip-
address file-name
}
(Optional) upload the system boot file
through FTP or TFTP.
1.4.3 Managing configuration files
Configuration files are loaded after starting the system; different files are used in different
scenarios in order to achieve different service functions. After starting the system, you can
configure the A10E/A28E and save the configuration files. New configuration will take effect
in next boot.
Configuration file has an affix ".cfg", and these files can be opened by text program in
Windows system. The contents in the following format:
Saved as Mode+Command format.
Just reserve the non-defaulted parameters to save space (refer to command reference for
default values of configuration parameters).
Take the command mode for basic frame to organize commands, put commands of one
mode together to form a section, the sections are separated by "!".
The A10E/A28E starts initialization by reading configuration files from memory after
powering on. Thus, the configuration in configuration files are called initial configuration. If
there is no configuration files in memory, the A10E/A28E take the default parameters for
initialization.
The configuration that is currently used by the A10E/A28E is called running configuration.
You can modify the A10E/A28E current configuration through CLI. The running
configuration can be used as initial configuration when next time power on, you must use
command write to save current configuration into memory and form configuration file.
Configure the configuration files management for the A10E/A28E as below.
Alpha-A28E#download startup-
config { ftp [
ip-address user-
name password file-name
]
[ reservedevcfg ] | tftp [
ip-
address file-name
]
[ reservedevcfg ] }
(Optional) download the startup
configuration file through FTP or
TFTP.
Alpha-A28E#erase [
file-name
]
(Optional) delete files saved in the
memory.
Alpha-A28E#upload startup-config
{ ftp [
ip-address user-name
password file-name
] | tftp [
ip-
address file-name
] }
(Optional) upload the startup
configuration file through FTP or
TFTP.
(Optional) save the running
configuration file into the memory.
To Next Page
Loading...