Orion A10E - Checking Configurations; Configuring the Egress Interface Totrunk Mode; Maintenance

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
48
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration
mode.
2
Alpha-A28E(config)#mls double-tagging
tpid tpid
(Optional) configure TPID.
3
Alpha-A28E(config)#interface port
port-id
Enter physical layer interface
configuration mode.
4
Alpha-A28E(config-port)#switchport
vlan-mapping vlan-list add-outer
vlan-id [ cos cos-value ]
Configure selective QinQ rules
on the interface.
2.3.6 Configuring the egress interface toTrunk mode
Configure basic QinQ or selective QinQ on the network side interface as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#interface
port port-id
Enter physical layer interface
configuration mode.
3
Alpha-A28E(config-
port)#switchport mode trunk
Configure interface trunk mode,
allowing double Tag packet to pass.
2.3.7 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show switchport qinq
Show configurations of
basic QinQ.
2
Alpha-A28E#show interface interface-type
interface-number vlan-mapping add-outer
Show configurations of
selective QinQ.
2.3.8 Maintenance
Use the following commands to check configuration results.
Item
Description
Alpha-A28E(config)#clear double-tagging-vlan
statistics outer { vlan - id | any } inner
{ vlan - id | any }
Clear statistics of double
VLAN Tag packets.