Orion A10E - Configuring Interface Mode; Configuring VLAN Attributes

Orion Networks
A10E/A28E/A28F Configuration Guide
2 Ethernet
Orion Networks
43
Function
Default value
Native VLAN of the Trunk interface
VLAN 1
Allowed VLAN in Trunk mode
All VLANs
Allowed Untag VLAN in Trunk mode
VLAN 1
2.2.4 Configuring VLAN attributes
Configure VLAN attributes as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration
mode.
2
Alpha-A28E(config)#create vlan vlan-
list { active | suspend }
Create VLAN.
The command can also be used
to create VLAN in batches.
3
Alpha-A28E(config)#vlan v lan-id
Enter VLAN configuration
mode.
4
Alpha-A28E(config-vlan)#name vlan-
name
(Optional) configure VLAN
name.
5
Alpha-A28E(config-vlan)#state
{ active | suspend }
Configure VLAN in active or
suspend status.

The VLAN created by the command vlan vlan-id is in suspend status, you need to
use the command of state active to activate VLAN if they want to make it effective
in system.

By default, there is VLAN 1, the default VLAN (VLAN 1), all interfaces in Access
mode belong to the default VLAN. VLAN 1 cannot be created and deleted.

By default, the default VLAN (VLAN 1) is called Default; cluster VLAN Other VLAN
is named as "VLAN + 4-digit VLAN ID", for example, VLAN 10 is named VLAN
0010 by default, and VLAN4094 is named as "VLAN 4094" by default.

All configurations of VLAN are not effective until the VLAN is activated. When
VLAN status is Suspend, you can configure the VLAN, such as delete/add
interface, set VLAN name, etc. The system will keep the configurations, once the
VLAN is activated, the configurations will take effect in the system.
2.2.5 Configuring interface mode
Configure interface mode as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
Note