A10E/A28E/A28F Configuration Guide
Figure 2-7 VLAN mapping application networking
Configuration steps
Configurations of Switch A and Switch B are the same. Take Switch A for example.
Step 1 Create VLANs and activate them.
Alpha-A28E#hostname SwitchA
SwitchA#config
SwitchA(config)#create vlan 100,200,1000,2008 active
SwitchA(config)#vlan-mapping enable
Step 2 Set Port 1 to Trunk mode, allowing packets of VLAN 1000 and VLAN 2008 to pass.
SwitchA(config)#interface port 1
SwitchA(config-port)#switchport mode trunk
SwitchA(config-port)#switchport trunk allowed vlan 1000,2008 confirm
SwitchA(config-port)#exit
Step 3 Set Port 2 to Trunk mode, allowing packets of VLAN 100 to pass. Enable VLAN mapping.
To Next Page
Loading...