Orion A10E - Configuring Remote Qinq

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
328
Configure the CO device as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#interface
port port-id
Enter physical layer interface
configuration mode.
3
Alpha-A28E(config-
port)#remote-device
Enter remote configuration mode.
4
Alpha-A28E(config-
remote)#vlan { dot1q |
forbid | port }
(Optional) configure remote VLAN
status.
5
Alpha-A28E(config-
remote)#vlan cos enable
(Optional) enable remote VLAN CoS.
6
Alpha-A28E(config-
remote)#vlan { cable-port |
cpu-port | fiber-port }
{ tag | untag } priority
priority pvid pvid
(Optional) configure remote VLAN tag
property.
7
Alpha-A28E(config-
remote)#vlan group group-id
vid vid member-list member-
list
(Optional) create remote VLAN group.
9.5.15 Configuring remote QinQ
Whether the remote device supports this function varies with the specific remote
device. For details, see the corresponding manuals.
Configure the CO device as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#interface
port port-id
Enter physical layer interface configuration
mode.
3
Alpha-A28E(config-
port)#remote-device
Enter remote configuration mode.
4
Alpha-A28E(config-
remote)#switch-mode
transparent
(Optional) configure remote device to work
in full transparent transmission mode.
5
Alpha-A28E(config-
remote)#switch-mode dot1q-
vlan native-vlan vlan-id
[ line ]
(Optional) enable remote device to work
single Tag forwarding mode.