Orion A10E - Configuring Basic Functions of EFM; Default Configurations of EFM

Orion Networks
A10E/A28E/A28F Configuration Guide
8 OAM
Orion Networks
264
Prerequisite
Before configuring EFM, you need to connect interfaces and configure physical parameters
on interfaces. Make the physical layer Up.
8.1.3 Default configurations of EFM
The default configuration of EFM is as below.
Function
Default value
EFM working mode
Passive mode
Sending interval of messages
10 × 100ms
Timeout of links
5s
OAM
Disable
Remote OAM event alarm function
Disable
EFM remote loopback state
Not response
Monitor window of error frame event
1s
Monitor threshold of error event
1 error frame
Monitor window of error frame period event
1000ms
Monitor threshold of error frame period event
1 error frame
Monitor window of link error frame second statistics event
60s
Monitor threshold of link error frame second statistics event
1s
Monitor window of link error coding statistics event
100ms
Monitor threshold of error coding statistic event
1s
Fault indication
Enable
Local OAM event alarm
Disable
8.1.4 Configuring basic functions of EFM
Configure basic functions of EFM for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.