Orion A10E - Figure 9-10 Configuring Basic Functions of LLDP

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
314
Figure 9-10 Configuring basic functions of LLDP
Configuration steps
Step 1 Enable LLDP globally and enable LLDP alarm.
Configure Switch A.
Alpha-A28E#hostname SwitchA
SwitchA#config
SwitchA(config)#lldp enable
SwitchA(config)#snmp-server lldp-trap enable
Configure Switch B.
Alpha-A28E#hostname SwitchB
SwitchB#config
SwitchB(config)#lldp enable
SwitchB(config)#snmp-server lldp-trap enable
Step 2 Configure management IP addresses.
Configure Switch A.
SwitchA(config)#create vlan 1024 active
SwitchA(config)#interface port 1
SwitchA(config-port)#switchport access vlan 1024
SwitchA(config-port)#exit
SwitchA(config)#interface ip 1
SwitchA(config-ip)#ip address 10.10.10.1 1024