Orion A10E - Checking Configurations; Enabling Optical Module DDM; Enabling Optical Module DDM to Send Trap Messages

Orion Networks
A10E/A28E/A28F Configuration Guide
9 System management
Orion Networks
334
Function
Default value
Optical module DDM
Disable
Optical module DDM sending Trap function status
Enable
9.6.4 Enabling optical module DDM
Enable optical module DDM for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#transceiver
digitaldiagnotic enable
Enable optical module DDM.
9.6.5 Enabling optical module DDM to send Trap messages
Enable optical module DDM to send Trap messages for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-
A28E(config)#snmp trap
transceiver enable
Enable optical module DDM to send Trap
messages.
9.6.6 Checking configurations
Use the following commands to check configuration results.
No.
Item
Description
1
Alpha-A28E#show interface
port [ port-id ] transceiver
[ detail ]
Show configurations of optical module
DDM.
2
Alpha-A28E#show interface
port [ port-id ] transceiver
[ detail ] threshold-
violations
Show performance parameters and
thresholds of optical module DDM.
3
Alpha-A28E#show interface
port [ port-id ] transceiver
information
Show information about the optical
module DDM.