A10E/A28E/A28F Configuration Guide
Alpha-A28E(config)#logging rate 2
Alpha-A28E(config)#logging host 20.0.0.168 local3 warnings
Checking results
Show system log configurations by the command of show logging.
Alpha-A28E#show logging
Syslog logging:Enable, 0 messages dropped, messages rate-limited 2 per
second
Console logging:Enable, level=informational, 19 Messages logged
Monitor logging:Disable, level=informational, 0 Messages logged
Time-stamp logging messages: date-time
Log host information:
Target Address Level Facility Sent Drop
----------------------------------------------------------------------
20.0.0.168 warnings local3 0 0
9.8 Power monitoring
9.8.1 Introduction
The A10E/A28E supports monitoring power alarm, namely, Dying Gasp alarm.
9.8.2 Preparing for configurations
Scenario
You can configure the power alarm function to monitor faults. When the power is abnormal,
the system generates the Syslog or sends Trap message, informing you to take actions
accordingly to avoid power failure.
Prerequisite
N/A
9.8.3 Default configurations of power monitoring
Configure the A10E/A28E as below.
Power alarm Trap sending status
To Next Page
Loading...