A10E/A28E/A28F Configuration Guide
6.3.5 Configuring static binding of dynamic ARP inspection
Configure static binding of dynamic ARP inspection for the A10E/A28E as below.
Enter global configuration mode.
Alpha-A28E(config)#ip arp-
inspection static-config
Enable global static ARP binding.
Alpha-A28E(config)#ip arp-
inspection binding
ip-address
[
mac-address
] [ vlan
vlan-
id
] port
port-id
Configure the static binding
relationship.
6.3.6 Configuring dynamic binding of dynamic ARP inspection
Before enabling dynamic binding of dynamic ARP inspection, you need to use the ip
dhcp snooping command to enable DHCP Snooping.
Configure dynamic binding of dynamic ARP inspection for the A10E/A28E as below.
Enter global configuration mode.
Alpha-A28E(config)#ip arp-
inspection { dhcp-snooping |
dhcp-relay }
Enable global dynamic ARP binding.
6.3.7 Configuring protection VLAN of dynamic ARP inspection
Configure protection VLAN of dynamic ARP inspection for the A10E/A28E as below.
Enter global configuration mode.
Alpha-A28E(config)#ip arp-
inspection { dhcp-snooping |
dhcp-relay }
Enable global dynamic ARP binding.
Alpha-A28E(config)#ip arp-
inspection vlan
vlan-list
Configure protection VLAN of
dynamic ARP inspection.
6.3.8 Configuring rate limiting on ARP packets on the interface
Configure rate limiting on ARP packets on the interface for the A10E/A28E as below.
To Next Page
Loading...