Orion A10E - Configuring Manual Link Aggregation; Configuring Static LACP Link Aggregation

Orion Networks
A10E/A28E/A28F Configuration Guide
7 Reliability
Orion Networks
207
Function
Default value
LACP interface priority
LACP priority without specifying interface
Interface dynamic LACP link
aggregation
Disable
7.1.4 Configuring manual link aggregation
Configure manual link aggregation for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
2
Alpha-A28E(config)#trunk
group group-id port port-
list
Configure link aggregation group.
3
Alpha-A28E(config)#trunk
enable
Enable link aggregation group.
4
Alpha-A28E(config)#trunk
loading-sharing mode { dip |
dmac | sip |smac | sxordip |
sxordmac }
(Optional) configure load sharing mode
for link aggregation.
In the same link aggregation group, member interfaces that share loads must be
identically configured. These configurations include QoS, QinQ, VLAN, interface
properties, and MAC address learning.

QoS: traffic policing, rate limit, SP queue, WRR queue scheduling, interface
priority and interface trust mode.

QinQ: QinQ enabling/disabling status on the interface, added outer VLAN tag,
policies for adding outer VLAN Tags for different inner VLAN IDs.

VLAN: the allowed VLAN, default VLAN and the link type (Trunk or Access) on
the interface, subnet VLAN configurations, protocol VLAN configurations, and
whether VALN packets carry Tag.

Port properties: whether the interface is added to the isolation group, interface
rate, duplex mode, and link Up/Down status.

MAC address learning: whether enabling the MAC address learning, and
whether the MAC address limit is configured on the interface.
7.1.5 Configuring static LACP link aggregation
Configure static LACP link aggregation for the A10E/A28E as below.
Step
Configuration
Description
1
Alpha-A28E#config
Enter global configuration mode.
Note