A10E/A28E/A28F Configuration Guide
Alpha-
A28E(config)#lacp
system-priority
system-priority
(Optional) configure system LACP priority. The
higher priority end is active end. LACP chooses
active and backup interfaces according to the
active end configuration. The smaller the number
is, the higher the priority is. The smaller system
MAC address device will be chosen as active end
if devices system LACP priorities are identical.
Alpha-
A28E(config)#lacp
timeout
{ fast |
slow }
Configure LACP timeout mode.
Alpha-
A28E(config)#trunk
group
group-id
port
port-list
[ lacp-
static ]
Create a static LACP link aggregation group.
Alpha-
A28E(config)#interfac
e port
port-id
(Optional) enter physical layer interface
configuration mode.
Alpha-A28E(config-
port)#lacp port-
priority
port-
priority
(Optional) configure LACP priority on the
interface. It affects electing the default interface
of LACP. The smaller the value is, the higher the
priority is.
Alpha-A28E(config-
port)#lacp mode
{ active | passive }
(Optional) configure LACP mode for member
interfaces. If both two ends of a link are in
passive mode, LACP connection cannot be
established.
Alpha-A28E(config-
port)#exit
Return to global configuration mode.
Alpha-
A28E(config)#trunk
enable
Enable link aggregation group.
Alpha-
A28E(config)#trunk
loading-sharing mode
{ dip | dmac | sip
|smac | sxordip |
sxordmac }
(Optional) configure load sharing mode for the
aggregation link.
Alpha-
A28E(config)#trunk
group
group-id
min-
active links
threshold
(Optional) configure the minimum number of
active links in LACP link aggregation group.
Interface in static LACP link aggregation group can be in active or standby status.
Both active interface and standby interface can receive/transmit LACP packets, but
standby interface cannot forward client packets.
To Next Page
Loading...