Orion A10E - Example for Applying IGMP Filtering and Maximum Multicast Group Number to the Interface

Orion Networks
A10E/A28E/A28F Configuration Guide
5 Multicast
Orion Networks
140
MVR Timeout: 600 (second)
MVR Mode: Dynamic
Mvr general query translate vlan: 0
Check whether the multicast VLAN and group address information are correct.
Alpha-A28E#show mvr vlan group
Vlan Group Address
-----------------------------
3 225.1.1.1
3 234.5.6.7
Group address entries for all Vlans: 2
Check whether IGMP Proxy configurations are correct.
Alpha-A28E#show mvr proxy
Mvr Proxy Suppression Status: Enable
Ip Igmp Querier Status: Enable
Mvr Proxy Source Ip: 192.168.1.2
Mvr Proxy Version: V2
Ip Igmp Query Interval(s): 60
Query Response Interval(s): 10
Last Member Query Interval(s): 1
Next IGMP General Query(s): 60
5.7.3 Example for applying IGMP filtering and maximum multicast
group number to the interface
Networking requirements
Enable IGMP filtering on the switch. Add filtering rules on the interface to filter multicast
users.
As shown below,

Create an IGMP filtering rule Profile 1, set the action to pass for the multicast group
ranging from 234.5.6.7 to 234.5.6.10.

Apply filtering IGMP filtering rule Profile 1 on Port 2, allow the set top box to join the
234.5.6.7 multicast group, forbid it to join the 234.5.6.11 multicast group.

Apply no filtering rule on Port 3, and allow PCs to join the 234.5.6.11 multicast group.
Configure the maximum multicast group number on Port 2. After the set top box is added to
the 234.5.6.7 multicast group, add it to the 234.5.6.8 multicast group. Then, it quits the
234.5.6.7 multicast group.